Teledex Y Series User Manual download pdf (Page 15)

Y SERIES EXP212, EXP224, AND EXP248 USER GUIDE www.teledex.com 15

status of the loop to be “open” or “close” to the

alarm equipment (close between ALMOUT and

ALMCOM for alarm; open if no alarm).

The pin assignment of housekeeping and alarm

contact output interface is illustrated below:

Figure 1.12 Pin Assignment of Housekeeping

Inputs and Alarm Contact Output (EXP248 Only)

Figure 1.13 Operation Diagram of Housekeeping

Inputs and Alarm Contact Output (EXP248 Only)

Note—The maximum current and voltage for

ALMOUT/ALMCOM is restricted to 0.5 A 30 VDC

or 0.15 A 125 VAC (resistive load).

1.3 Provisioning a Management

IP Port (EXP212, EXP224)

This section describes how to use CLI commands

and Web Configuration Tool to provision an IP

port for the DSLAM.

Before changing the system IP address, you can

connect to the DSLAM via console port and type

in the following CLI command to check current

setting:

enable

show management all /*Display all system

management port IP setting*/

To provision an IP port:

IN CLI

enable

configure

management gbe <ipv4 address> [netmask

<netmask>] /*Set in-band management port IP

setting*/

management gbe vlan <vlan id> /*Restrict

incoming VLAN tag of in-band management; this

setting is optional not mandatory*/

route default <ipv4 address> /*Set IP address of

the default gateway*/

runningcfg write partition <number> /*Save

new settings to memory (partition)*/

IN WEB GUI

a. On the menu tree, click on System --->

Board Setup. The Board Setup page is

displayed.

b. Type in new IP setting in the GBE (In Band)

section for in-band IP provisioning.

c. Click on Modify button to submit the

modification.

To save new setting to flash memory:

On the menu tree, click on Maintenance --->

Database. The Database Configuration page is

displayed. Click on the DB Config drop-down list

and select Save Running Config to Flash. Select

write flash at Partition 1 or Partition 2. Then click

on Write_Running button. Wait for memory write

success message.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 31 32

Comments to this Manuals

No comments

Teledex Y Series User Manual Page 15

Comments to this Manuals

Related products and manuals for Phones Teledex Y Series